Since construction machinery is a special vehicle, the operator should accept the training and guidance of the manufacturer, have a full understanding of the structure and performance of the machine, and obtain certain operation and maintenance experience before operating the machine. The "Product Operation and Maintenance Manual" provided by the manufacturer is the necessary information for the operator to operate the equipment. Before operating the machine, be sure to read the "Operation and Maintenance Manual" and perform operation and maintenance as required.
Pay attention to the work load during the run-in period. Half of the work load during the run-in period should not exceed 60% of the rated work load, and a suitable workload should be arranged to prevent the occurrence of overheating caused by the continuous operation of the machine for a long time.
Pay attention to frequently observe the indications of each instrument, and stop the operation in time to eliminate the abnormality, and stop the operation before the cause is found and the fault is not eliminated.
Pay attention to frequently check the level and quality of lubricating oil, hydraulic oil, coolant, brake fluid and fuel oil (water), and pay attention to check the sealing of the whole machine. During the inspection, it is found that there is too much oil and water shortage, and the reason should be analyzed. At the same time, the lubrication of each lubrication point should be strengthened. It is recommended that during the running-in period, grease should be added to the lubrication point in each shift (except for special requirements).
Keep the machine clean, adjust and fasten loose parts in time to prevent the loose parts from aggravating the wear of parts or causing parts to be lost.
At the end of the running-in period, the machine should be compulsorily maintained, checked and adjusted, and at the same time, pay attention to the replacement of the oil. In short, the requirements for the use and maintenance of the loader during the running-in period can be summarized as: strengthening training, reducing load, paying attention to inspection, and strengthening lubrication. As long as you pay attention to and implement the maintenance and maintenance of the loader during the running-in period as required, it will reduce the occurrence of early failures, prolong the service life, improve the working efficiency, and bring more benefits to you.




